Filter
Top Products
Center gate in opening. Gaps on each side
should be equal.
Min: 1”
Max:
3”
Place hinge spindles (c) over hinge bottom
posts (b), dropping them into place. Adjust
latch spindles (m) out until they fit securely
into two locking brackets. Latch spindle at
top must be adjusted so it clicks under
locking latch when in closed position.
Space between end of gate and mounting
surface should be no less than 1” and not
more 3” on each side.
Check that gate can be easily opened and
closed without catching.
Place a spring (d) and hinge cap (e) on each
hinge post. This may require some manipula-
tion to ensure hinge posts fit and holes line
up. Insert remaining 2 screws and tighten.
With wrench (n) tighten lock nuts on all
spindles towards gate.
WARNING. Spring must be placed OVER
hinge spindle and hinge cap must be
installed as directed.
7