Filter
Top Products
6
Operation
6. Pull out the two bottom spindles (s) until they touch
mounting surface and rest on top of floor molding
(if applicable). Tighten handwheels TOWARD GATE
FRAME as tightly as possible. Each spindle adjusts
individually and may be extended to varying lengths to
allow for molding, uneven walls, etc.
IMPORTANT: If gate is properly tightened the yellow
and red pressure indicators will be absent (6a). If the
RED pressure indicator is present further tightening is
required (6b). If yellow is still present, gate installation
is acceptable but additional tightening is encouraged
(6c).
7. Close walk through door so locator (l) is aligned
directly above bottom gate rail. Do not lower handle.
Pull out the top spindle (b) on the hinge side (m) until
it touches the mounting surface. Tighten handwheel
TOWARD GATE FRAME until locator drops and rests
on bottom gate rail.
8. Pull out spindle (b) in the handle side until it touches
mounting surface and tighten handwheel TOWARD
GATE FRAME so the distance between pressure plate
(o) and pressure hinge (area A) is sufficient for walk
through door to open in either direction.
9. IMPORTANT: There is a pressure indicator on the
handle. If gate is properly tightened yellow and red
indicators will be absent (9a). If RED is present further
tightening is required (9b). If yellow is still present, gate
installation is acceptable but additional tightening is
encouraged (9c).
Warranty
KIDCO LIMITED WARRANTY
Your KidCo product is warranted to be free from manufacturing defects for a period of one year from date of
purchase under normal non commercial use and in compliance with the operating instructions. This warranty
extends only to the original retail purchaser and is only valid when supplied with proof of purchase.
KidCo will either repair, or at our option replace, free of charge, any parts necessary to correct defects in
material or workmanship during the warranty period. This warranty is complete and exclusive. The warranty
expressly disclaims liability for incidental, special and consequential damages of any nature. Any implied
warranty arising by operation of law shall be limited in operation to the terms of this warranty. Some states
do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an
implied warranty lasts, so the above may not apply to you. This warranty gives you specific legal rights, and
you may have other rights which vary from state to state.
SHOULD REPAIR OR PARTS BE NECESSARY
Should a repair be needed during the warranty period, ship the gate in the original carton or similar protective
container (check any retail store or purchase from UPS) and send freight prepaid (we suggest UPS) to:
KidCo, Inc., 1013 Technology Way, Libertyville, IL 60048-5349.
Include a note with your return address, day-time telephone number, and specify what is wrong with the product.
Repairs can normally be made within 48 hours after receipt at KidCo. For additional information CALL our
customer service department at (800) 553-5529.
Installation
10. To Open Gate.
Release locking mechanism by pressing buttons (r)
in while lifting handle. BUTTONS MUST ALWAYS
BE PRESSED IN WHEN LIFTING HANDLE. Lift walk
through door so hinge is raised and door will swing
open in either direction.
To Close Gate.
Lift walk through door. Position locator (l) until it is
above the bottom rail. Make sure hinge has dropped
down. Push handle down to lock.
Gate should always be in locked position when in
use.
11. Installation aid
KidCo has available OPTIONAL Y spindles (Model GY-1)
to assist in installation when the mounting surface has
a round baluster. These spindles are used in place of
the spindles included with the basic gate. They may be
ordered through your local KidCo dealer or direct from
KidCo.
No more than 2 Y spindles may be used per gate
and both must be used on the same side.