Filter
Top Products
INSTALLING
12
p/n GH 19502091
min. 6 inches
min. 1
37
/64 inches
Max
Min
PTO shaft adaption
The PTO shaft, supplied with the machine, is of standard
length. Therefore it might be necessary to adapt the PTO
shaft. Consult your dealer for the eventual adaptation.
• The equipment installed can only be controlled by means
of the PTO shaft complete with the necessary overload
safety (i.e. clutch) devices and guards fastened with the
appropriate chain.
• Only the PTO shaft supplied by the Manufacturer must be
used.
• The engine must not be running when installing and
removing the PTO shaft.
• Care must be taken regarding the safety and correct
assembly of the PTO shaft.
• Use the chain provided to stop the PTO shaft from rotating.
• Always check carefully that the PTO shaft guard is always
in position, both during transportation and operation.
• Frequently and set intervals check the PTO shaft guard, it
must always be in excellent condition.
• Before engaging the PTO, check that the set rpm
corresponds to that indicated by the sticker on the
equipment.
• Before inserting the PTO, make sure that there are no
people or animals nearby and that the rpm selected
corresponds to that permitted. Never exceed the maximum
admissible speed.
• Watch out for the rotating universal joint.
• Do not insert the PTO with the engine off or synchronized
with the wheels.
• Always disconnect the PTO when the cardan shaft is at too wide an angle (never more than 10°,Fig.
12) and when it is not being used.
• Only clean and grease the PTO shaft when the power take-off is disconnected, the engine is off, the
hand brake pulled and the key removed.
• When not in use, place the PTO shaft on the support provided for it.
• After having dismantled the PTO, place the protective cover on the PTO shaft (R, Fig. 13).
ATTENTION
Comply with the manufacturer's instructions when
transporting the mowing machine.
CAUTION
• When the PTO shaft is fully extended, the two tubes
must overlap by at least 6 inches (P Fig. 11). When
fully inserted, the minimum play must be 1
37
/64
inches (Q Fig.11).
• If the implement is used on another tractor, always
check the above and that the guards copletely
cover the rotating parts of the PTO shaft.
R
Fig. 13
Fig. 12
Fig. 11
P
Q