Filter
Top Products
Dual Release Walkers 4 Part No 1167481
3 Usage
3.1 Opening/Folding the Walker
1. Swing both side frames (A) out away from the front
crossbrace (B) until an audible "click" is heard and
both locking mechanisms (C) engage.
2. Test the walker by grasping the side frames (A) and,
with some force, try to fold them inward.
3. To fold the walker, press down on the locking
mechanisms (C) and fold the side frames (A) in
toward the front crossbrace (B).
3.2 Installing/Adjusting Leg Extensions
1. Press the snap button and slide the leg extension
(D) onto the walker leg.
2. Adjust the leg extension to the desired height and
allow the snap button to snap into the height
adjustment hole.
3. Repeat STEPS 1 and 2 as necessary.
4. Make sure that the walker is level.
ƽ
WARNING
Pinch points exist between the frame
tubes when opening and folding the
walker. Make sure hands and body are
clear of all pinch points.
ƽ
WARNING
BEFORE use, both sides of the walker
MUST be open and in locked position.
ƽ
WARNING
The walker MUST be level before use.
When using wheeled attachments on the
front legs, the rear leg extensions MUST
be adjusted to make the side frames level.
Pinch points exist when installing and
adjusting leg extensions. Make sure hands
and body are clear of all pinch points.
Wheeled leg extensions MUST be
installed with the wheels on the outside
of the walker.
An audible “click” will be heard.
C
A
B
DETAIL “A” -
LOCKING MECHANISM
Not engaged (down)
Engaged (up)
Snap Button
(fully engaged)
Leg
Extension
DETAIL “B” -
LEG EXTENSION SNAP BUTTON
Correct
D
Incorrect
Snap Button
(not engaged)