Filter
Top Products
6 7
Changing the Image Disc
1.Make sure projection is off, then slide down the projector door and pull out the disc holder (Fig 7).
2.Gently remove the current disc and set aside (Fig 7).
3.Select a new disc from the disc storage slots (Fig 6) and place into the disc holder so that you can see the word “UP”
printed on the disc (Fig 8).
4.Slide the disc holder back into the unit and push projector door up to close (Fig 6).
NOTE: The projector door must be completely closed, pushed all the way up, in order for the
picture projector to function (Fig 6).
5. Put original image disc into empty disc storage slot (Fig 6).
Using the Picture Projection
NOTE: The projector door must be completely closed, pushed all the way up, in order
for the picture projector to function (Fig 6).
1. Turn on the picture projection on by pressing the PROJECTION ON/OFF button (Fig 3).
2. To adjust the brightness of the projection, turn the HI/LO knob (Fig 5) to your desired level.
3. The angle of the projector can be adjusted by angling forward up to 90°
4. When finished using the picture projection you may turn it off by pressing the PROJECTION
ON/OFF button.
NOTE: SOUNDS and PROJECTION are independent functions. You can use one at a time or
both combined.
FIGURE 5
FRONT
OF UNIT
HIGH/LO
KNOB
BACK OF UNIT
FIGURE 6
DISC STORAGE SLOTS
UP FOR PROJECTION
DOWN
FOR
DISC
JACK
PROJECTOR DOOR
FIGURE 8
FIGURE 7
PROJECTION LENS
IMAGE
DISC
DISC HOLDER
PROJECTOR
DOOR
DISC STORAGE SLOTS
IMAGE
DISC
“UP”
DISC HOLDER
PROJECTOR
DOOR