Filter
Top Products
SKU 95041 For technical questions please call 1-800-444-3353. Page 3
Operation
Your Key Box comes completely assembled. It is important that you read the entire manual to
become familiar with the product BEFORE you set up and use the Key Box.
1. Opening the Key Box for the first time: On the Keypad (7) enter the factory preset
Personal Identification Number (PIN) which is 159B. When the Green LED light goes on,
turn the Knob (4) clockwise and the Key Box will open-see Assembly Diagram.
2. To program your own PIN: On the Keypad (7) enter the factory preset PIN which is 159B.
When the Green LED Light goes on, turn the Knob (4) clockwise and the Key Box will open-
see Assembly Diagram. Press the Red Button (11) on the inside of the door near the hinges.
Select a new PIN, with 3 to 8 numbers, and press the “B” key.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking your Key Box, check to make sure that all parts listed in the parts list on page 5 are
included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
1-800-444-3353. It is important that you read the entire manual to become familiar with the product
BEFORE you operate and use the Key Box.
N0TE: Harbor Freight Tools is not responsible for the loss of any property stored
within this safe due to theft, fire, or any other circumstance.
The green light will go on to indicate that the PIN has been successfully programmed. Make
a note of the new PIN and store it in a safe place away from the Key Box.
Test your new PIN before closing the door. Make certain you have a Manual Override Key(8)
available when setting a new PIN or changing batteries in case the door doesn’t open.
Note: The Knob (4) on the Door must be turned within 5 seconds of the green light coming on, or
else the PIN must be re-entered.
Note: If you or an intruder incorrectly enter the PIN, the yellow light will go on.
Entering an incorrect
PIN three times will freeze the system for 20 seconds.
3. Using the Manual Override Key (8) : The Manual Override Keys can be used if you
forget your PIN, if the batteries are not installed in the Key Box, or if the batteries are dead.
NEVER lock your Manual Override Keys (8) into the Key Box, store them seperately
in a safe place.
4. At the center of the Key Box door (see Assembly diagram) is the Key Cover (5). Remove the
Cover (5) and pull the panel outward to expose the key hole. Insert the Manual Override
Key (8) and turn counterclockwise. Turn the Knob and pull the door open.