Harbor Freight Tools 92953 Building Set User Manual


  Open as PDF
of 4
 
Page 3SKU 92953 For technical questions, please call 1-800-444-3353.
9. DO NOT APPLY FORCE OR A SHOCK TO THE CALIPER.
10. DO NOT DISASSEMBLE THE CALIPER.
OPERATING INSTRUCTIONS
To Prepare The Caliper For Use:
1. Make sure the upper and lower Outside Diameter Jaw surfaces are clean.
2. Close the Outside Diameter Jaws completely but gently.
4. At this point, the Slide Scale Measurement Point should read “0”.
5. Set the Dial by turning the Dial Adjustment until the Dial Needle points to “0”.
6.
The Caliper is now ready for use.
To Read The Scale And Dial:
1. The Beam Scale Measurement Point features readings in inches.
2. The Dial features readings in inches.
3. First, read the Slide Scale Measurement Point (in inches and tenths of inches),
i.e., 0.5”. Then, read the Dial Needle on the Dial (in 1/128”), i.e., 2/128” or 1/64”.
4. Combine the two measurements for the final reading, 33/64” (1/2” + 1/64”).
UNPACKING
When unpacking, check to make sure that the product is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as
soon as possible.
To Use The Caliper:
1. To measure the
outside
diameter of an object see Figure B.
2. To measure the
inside
diameter of an object see Figure C.
FIGURE B FIGURE C
 previous