Filter
Top Products
-6-
T26413/T26414/T26415 (Mfd. 9/13+)
Cleaning & Protecting
Wipe the arbor press down with a clean shop rag
and mineral spirits. When dry, protect the unpaint-
ed surfaces by applying a thin film of ISO 32 oil.
Lubrication
Ball Oilers
Oil Type ......Model T23963 or ISO 32 Equivalent
Oil Amount .........................................1–2 Pumps
Lubrication Frequency ...........8 Hrs. of Operation
Proper lubrication of the two ball oilers (see
Figure 13) is done with a pump-type oil can that
has a plastic or rubberized cone tip. We do not
recommend using metal needle or lance tips, as
they can push the ball too far into the oiler, break
the spring seat, and lodge the ball in the oil galley.
Push the tip of the oil can nozzle against the ball
oiler to create a hydraulic seal, then pump the oil
can once or twice. If you see sludge and contami-
nants coming out of the lubrication area, continue
pumping the oil can until the oil runs clear. Move
the components through the entire path of travel a
few times to distribute the oil. When finished, wipe
away the excess oil.
Rack & Pinion
Grease .......Model T23964 or NLGI#2 Equivalent
Grease Amount ................................. As Needed
Lubrication Frequency .........40 Hrs. of Operation
Tools Needed Qty
Wrench or Socket 10mm (T26413) .................... 1
Wrench or Socket 12mm (T26414, T26415) ...... 1
To lubricate rack and pinion:
1. Remove front plate to remove ram and
expose pinion (see Figure 14).
2. Use shop rags, stiff brush, and mineral spirits
to clean teeth of rack and pinion.
3. When dry, apply a light coat of grease to rack
and pinion teeth.
4. Re-install ram and front plate.
5. Use sliding handle to move ram up and down
several times to distribute the grease.
Figure 13. Locations of ball oilers.
Ball Oilers
Figure 14. Ram rack and pinion.
Pinion
Ram
Rack