Filter
Top Products
T26413/T26414/T26415 (Mfd. 9/13+)
-5-
2. Remove the ram from press, then flip it end-
over-end as needed for operation.
3. Re-insert ram into housing and mesh ram
rack with pinion.
4. Re-install the front plate.
Adjusting Ram Play
Set screws on the front and left side of the ram
housing (see Figure 12) adjust the amount of ram
free-play. The ideal adjustment allows the ram to
move with very little play but not be overly stiff.
T26413 Tools Needed Qty
Wrench or Socket 10mm ................................... 1
Hex Wrench 3mm .............................................. 1
T26414-15 Tools Needed Qty
Wrench or Socket 14mm ................................... 1
Hex Wrench 4mm .............................................. 1
To adjust ram play:
1. Loosen hex nuts on set screws shown in
Figure 12.
Figure 12. Ram free-play adjustment controls.
2. Equally adjust each pair of set screws a
small amount in same direction (clockwise
to decrease free-play, counterclockwise to
increase free-play).
3. Use sliding handle to move ram up and down
a few times. Adjust set screws as necessary.
4. When you are satisfied with the amount of
ram free-play, retighten hex nuts without
moving set screws.
Figure 11. Ram rack and pinion.
Pinion
Ram
Rack