Filter
Top Products
30
Pull on latch plate (fig. a). If belt slides freely
through latch plate, a locking clip MUST
be used (see Pg. 31 “Locking Clip” section).
Some combination lap/shoulder belts with
sliding latch plates may be converted into an
“automatic locking mode” that will allow use
without a locking clip. See vehicle owner’ s
manual and label on vehicle belts for
instructions.
(fig. a)
❃
Combination Lap/Shoulder
Belt with Sliding Latch Plate
❃
Combination Lap/Shoulder
Belt with Locking Latch Plate
The locking latch plate on some seat belts may
slip and loosen after being buckled on child
restraint if positioned at a certain angle. If this
happens, flip the latch plate over (fig. b) and
re-buckle. Test installation again to see if this
works. If not, move child restraint to another
seating position.
Pull
VEHICLE SEAT BELTS (continued)
(fig. b)
Flip