Filter
Top Products
6785
751-6-99
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Open stroller on carton as
shown until latched.
Step 2.
Be sure frame is latched as
shown before continuing
assembly.
Step 1.
Snap swivel lock button onto
wheel mount as shown. This
must be done BEFORE pin is
inserted (next step).
Step 2.
Insert pin through hole in wheel
mount. Then push round end of
a front wheel assembly up onto
pin as shown until it snaps into
place.
Check wheel attachment by
pulling down on the front wheel
assembly.
Step 3.
Repeat above steps for the
other side.
Step 1.
Turn stroller over as shown.
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109 or visit our Internet website,
www.gracobaby.com.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
Pin (2)
Rear axle
Frame
Front wheel
assembly (2)
Flattened
carton
Rear
canopy
Front canopy
(only on
some models)
Retainer
(2, 1 extra)
Rear wheel (2)
Cap
(2, 1 extra)
Rear hubcap (2,
only on some models)
To Assemble Front Wheels
Latch
To Assemble Rear Wheels
Swivel lock
button (2)
Spokes
toward
inside
Rear
axle
Retainer (red)
Wide end toward wheel
Hubcap (only on
certain models)
Step 2.
Place ONE rear wheel, red retainer, cap, and hubcap (only on
certain models) on one end of rear axle in order as shown
below. Push red retainer onto axle BEFORE attaching white
cap. Do not place other wheel on axle at this time.
Wheel
Cap (white)
Attach AFTER
retainer is
on axle
Snap red retainer into axle
groove. Then snap cap over the
red retainer as shown. Be sure
cap is snapped securely over
red retainer. Snap the hubcap
(only on some models) on last.
Step 3.
Unsnap the basket flap from the
rear brace, and slide rear axle
with wheel assembly through
the hole in one axle bracket.
Continue to push the rear axle
into the hole of the other axle
bracket.
Step 4.
Snap the basket flap around
both the rear axle and the rear
brace.
This may be easier if the
stroller is partially folded.
See the To Fold Stroller
instructions.
Step 5.
Place other rear wheel onto the
rear axle. Snap the red retainer
and cap onto the axle as shown
in Step 2.
Step 6.
Only on certain models, snap
the remaining hubcap onto
rear wheel to complete the
assembly.
To Unfold Stroller
Step 1.
Release the latch found on
one side of stroller.
Step 2.
Unfold stroller as shown.
Be certain the
stroller is fully erected and
latched before allowing your
child near the stroller.
To Raise Footrests
Lift footrest and hook wire into
footrest bracket.
To Use Brakes
Always apply
both brakes to park stroller.
Push DOWN to park.
Lift UP to stroll.
Insert pin
Push
wheels up
Round
end