Filter
Top Products
9
749-12-97
1210 11
To Adjust Canopy
Push canopy forward.
Canopy bag (only on some
models) carries a maximum
of 2 pounds (0.9 kg).
On certain models, you can
unzip the rear panel and fold it
out of the way to see your
baby.
To Move Handle to
Carriage Position
Step 1.
For handle with wire, squeeze
in center to unlock.
OR
For handle without wire, pull
up on both plastic slides on
the handle to unlock, as
shown.
Step 2.
Move handle to new position.
Use care
when reversing handle to
avoid catching childs arms
or hands in the mechanism.
Push in both buttons at sides of
handle and slide handle to new
position.
Be sure handle is engaged in
one of the latching
positions.
To Raise Footrest
Lift footrest and hook wire into
footrest bracket.
Child may
slip into leg openings and
strangle. Never use in
reclined carriage position
unless footrest is placed
under padded front bar and
wire is snapped into lower
notch.
To Use Head Supports
(on certain models)
Back of cloth seat
pad
To use stroller with a smaller
child, pull the plastic pieces from
pockets located in the back of
the cloth seat pad, and reinsert
them with curved side toward
the front.
To use stroller with a larger child
who does not need head sup-
port, insert the plastic pieces
with the curved side toward the
back.
Step 3.
Push on secondary lock
on right side of stroller
(red button).
Step 4.
Lock storage latch as shown.
OR
To Fold Stroller
NOTE: Before folding, (1) remove boot if present; (2) adjust
back to upright position; (3) adjust handle to rear position;
(4) fold canopy.
Step 1.
Push on latch to fold as shown.
OR
To Adjust Handle Height
(on certain models)
Step 2.
Push handle forward.
HELPFUL HINTS
IF WHEEL SQUEAKS, use a
light oil (e.g., WD-40, 3-in-1,
or sewing machine oil). It is
important to get the oil into
the axle and wheel assembly
as shown.
WHEN USING YOUR STROLLER OVER
UNEVEN SURFACES (such as grass, stones
or gravel), lock all swivel wheels.
BEFORE LOCKING SWIVEL WHEELS, it is
important to first push the stroller forward a few
feet to ensure that the wheels are correctly
positioned.
WHEN USING YOUR STROLLER AT THE
BEACH, completely clean your stroller
afterward to remove sand and salt from
mechanisms and wheel assemblies.
IF FOOTREST BECOMES CAUGHT under
arm bar when unfolding your stroller, first refold
the stroller, pull footrest down into correct
position, then proceed to unfold your stroller.
IF STROLLER WONT STAND IN
UPRIGHT FOLDED POSITION,
check position of wheels to ensure
they are in the correct position as
shown.
CARE AND MAINTENANCE
DO NOT MACHINE WASH SEAT (with perma-
nent inner boards). It should only be wiped with
a mild detergent, taking care not to soak the
material. Seat with removable inner boards (on
certain models) may be machine washed in
lukewarm water on delicate cycle and drip-
dried. NO BLEACH.
REMOVABLE PAD may be machine washed
in lukewarm water on delicate cycle and drip-
dried. NO BLEACH.
FROM TIME TO TIME CHECK YOUR
STROLLER for loose screws, worn parts, torn
material or stitching. Replace or repair the parts
as needed. Use only Graco
®
replacement parts.
TO CLEAN STROLLER FRAME, use only
household soap or detergent and warm water.
NO BLEACH.
EXCESSIVE EXPOSURE TO SUN OR HEAT
could cause fading or warping of parts.
To Attach Boot
(on certain models)
Step 1.
Raise footrest and place boot
under footrest. Slide boot over
the front of stroller.
Step 2.
Snap straps at top of boot around
stroller frame on both sides as
shown.