Filter
Top Products
5
808-9-98
6 87
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
Frame
Rear wheel (2)
Cap
(2, 1 extra)
Front wheel
assembly (2)
To Assemble Front Wheels
To prevent
serious injury or death
from choking, remove and
IMMEDIATELY discard plastic
end caps on the front leg pins.
Step 1.
Remove and discard the plastic
end caps on the front leg
pins. Line up pin with a wheel
assembly as shown.
Plastic snap inside wheel
mount must be away from pin.
Push wheel assembly onto pin
until it snaps into place.
Step 2.
Repeat for other wheel assembly.
NOTE: Pull firmly on each wheel assembly to be
sure the wheel assemblies are securely attached.
End cap
To Assemble Rear Axle
Rear legs
Brake levers
point toward
you
Step 1.
Turn stroller over as pictured above.
Step 2.
Position rear axle assembly as shown.
Step 3.
Start both brackets onto leg tubes at the same time.
Step 4.
Push both brackets on until plastic tabs snap into the slots
on the legs.
Step 5.
Pull firmly on each bracket to be sure the brackets are
securely attached.
To Assemble Rear Wheels
Place one rear wheel, red retainer, and white cap on one end
of rear axle in order as shown below. Push red retainer onto
axle BEFORE attaching white cap. Repeat on other side.
Snap red retainer into axle
groove. Then snap cap
over red retainer as shown.
Be sure cap is snapped securely over red retainer.
To Attach Seat
Step 1.
Set the stroller frame upright.
Step 2.
Line up notches on sides of seat with plastic brackets on
frame. Lower seat onto frame until it snaps into brackets.
Seat can be installed facing either direction. Pull up on
each side of seat to be sure it is securely attached.
Step 3.
To remove seat to reverse position
or for cleaning, squeeze the levers
on both sides of seat and lift.
DO NOT lift, reverse or carry the seat
while child is in the seat.
Boot
(on certain models)
Rear axle assembly
Retainer
(2, 1 extra)
Seat
Canopy
Rear
axle
Retainer (red)
Wide end
toward wheel
Wheel
Cap (white)
Attach AFTER
retainer is on axle
Spokes
toward
inside
To Adjust Back
To raise or recline seat back,
pull up the plastic handle at
back of seat and adjust seat
back to desired position.
Seat back can adjust to five
different positions.
To Assemble Canopy
Step 1.
Position canopy over back
of stroller frame as shown.
Align the ends of the canopy
mounts with the openings in
the seat covering. Push the
canopy mounts into the slots
until they snap in place.
Step 2.
To remove canopy, push in
the button hidden under
the padding directly under
one canopy mount, and
pull the canopy mount out
of the slot. Repeat on other
side.
Button under
padding below
canopy mount
To Adjust Canopy
Push or pull canopy to desired
position.
Locking
latch
To Unpack Stroller
Step 1.
Flatten stroller carton to protect floor. Slide seat out
from frame and set it aside.
Step 2.
Open stroller frame
on carton by lifting
handle until locking
latches on both sides
are locked as shown.
OR