Filter
Top Products
Operation
3A0101B 9
Depth Control Wheels
Using Depth Control Wheels as a 5 in. or
10 in. Wide Cutting Guide
To make a 5 in. cut, install two spacers (S) on outside
of Depth Control Wheels (K).
To make a 10 in. cut, install two spacers (S) on inside
of Depth Control Wheels (K).
How to Level the Drum
To properly level the drum, GrindLazer must be resting
on a flat level surface.
1. Make sure drum is properly installed (see Drum
Replacement, page 6).
2. Push down on handle bars, pull engagement lever,
and lower drum into DOWN position.
3. Loosen (but do not remove) three bolts (T) on Depth
Control Wheel plate.
4. Adjust plate until guide wheels lay flat on surface.
5. Tighten three bolts (T) on plate.
S
S
K
K
ti15095a
5 in.
S
S
K
K
ti15094a
10 in.
T
ti15229a