Filter
Top Products
10 119
651-3-00 651699
To Adjust the Seat Height
Do not adjust height while child is in
activity center.
Step 1.
Press in the buttons on each
leg to adjust seat to desired
height.
For your
childs safety, all three legs
must be set to the same
height. Tray must be level.
Step 5.
Ball holder: Squeeze latches under tray to release
ball holder.
Pull ball holder out of tray. Open ball holder to
remove ball. Put ball into cup. Turn ball holder
upside down and reinsert into tray as a cup holder.
Push it all the way down onto tray.
Step 6.
Wand: Pull up on handle of butterfly wand to
detach it from tray for toddler to play with. Do not
pull butterfly off handle.
Step 7.
Seat: Store in a safe place, not exposed to sun or
heat, in case you wish to convert back to an infant
setup in the future.
Your Entertainer
®
should now look like the open-tray
toddler mode below.
B. Convert toys for toddler use
Step 1.
House: Replace on tray with
mirror facing outside of unit. Turn
base counterclockwise to fasten
it to tray.
Step 2.
Shape toys: Untie string under
tray and remove them. (Shapes
fit into different openings in
house.) Replace string, attached
only to phone, and retie again
under tray.
Step 3.
Ring loop: Remove by pulling ends slightly apart under
tray and pushing loop up. Remove rings. Turn loop upside
down. From underside of tray, insert ends of loop back into
holes and push up until peg ends snap in place. Put rings
onto pegs.
Step 4.
Cup: Reach underneath tray, wrap fingers around cup, and
squeeze toward you with both hands to release pivot pin of
cup from hole in tray. Turn cup around so handle is away
from house as shown, and reattach to tray. Cup now can
pivot to drop ball onto ball track beneath.
Step 2.
Turn house/mirror toy so that rib
on base of house (see closeup)
lines up with arrow on tray. Lift
house to remove.
Step 3.
Unscrew the three large plastic
bolts attaching tray to legs. Do
not try to pull bolts out of tray.
Remove tray from legs.
Step 4.
Underneath tray, pull back finger latch where the two halves
of tray meet. While holding latch, lift right side of tray up to
release it from left half. Pull tray open.
Step 5.
For each leg: (1) push and hold in the leg button; (2) push
leg down to the lowest position. (Top of inner leg section
must be slightly below top edge of outer leg.)
Tipping or fall hazard. Do not use in
toddler mode unless legs are set to lowest position.
Step 6.
Place open tray over base so
Graco
®
name is seen through
opening in trays as shown. Align
bolts over holes in legs.
Starting with bolt under the house,
partially tighten all bolts (to allow
alignment), then fully tighten.
Be sure bolts are tight. Pull up tray at each bolt to make
sure it is attached to leg.
Tray at proper height
Step 2.
After adjusting height of the seat, CHECK that your
childs feet can rest completely on the floor of your
activity center
. Tray should not be too high or too low.
Remove child and readjust height if necessary.
TRAY TOO HIGH TRAY TOO LOW
To Convert Your Convertible
Entertainer
®
for Toddler Use
When your child is able to walk, you can convert your
Entertainer
®
into the toddler mode. This open tray
arrangement, along with changing the toys to allow new
activities, can give your child a whole new play experience.
A. Change base and tray
Step 1.
From top of seat, reach
through the leg openings as
shown and pull plastic tabs
(also found at back and front
of seat) slightly inward while
lifting seat to remove.
Lift
Legs must be
at this height!
1. Push in
2. Push
down
Partially tighten
this bolt first
Mirror faces
outside of unit
Pull pin out
12