Graco 1000 STETM Bouncy Seat User Manual


 
OPERATIONS and ADJUSTMENTS
10
Recline / Upright Positions (fig. c:):
Rear-facing - MUST use Recline position.
Forward-facing - MUST use Upright position
Upright Position: Rotate stand out and push
into car seat.
Recline Position: Pull stand out and rotate
into car seat.
Harness straps MUST move freely. Make sure
harness straps are not pinched by recline stand.
5-Point Crotch Strap Adjustment (fig. d):
From bottom of car seat, pull crotch strap
clip out and remove clip from crotch
strap loop.
From top of car seat, pull crotch strap out
and thread through desired slot. Make
sure red button is facing away from child.
• From bottom of car seat, re-attach clip to
crotch strap loop exactly as shown.
Harness Straps (fig. a):
To tighten: Pull lower belt.
To loosen: Lift adjuster lever and pull
harness straps out.
Harness Tie (fig. b):
To open: Unhook harness tie from child’s
left side of harness straps.
To close: From backside of harness tie,
slide harness strap over harness tie tongue.
Buckle:
MUST be in opening closest to but not under
child.
5-Point Models
To buckle: Insert both tongues into
buckle. Pull up on tongues to be sure
they are locked.
To unbuckle: Press red button and pull
tongues out of buckle.
T-Shield & Overhead Shield Models
To buckle: Push tongue into opening.
Pull up on tongue to be sure it is locked.
To unbuckle: Press red button, pull
tongue out of opening and lift shield
over top of car seat.
1
2
4
3
5