Filter
Top Products
Manual GEMINI
Version: Sept. 2006
11
Adjusting the length of the foot support
Due to the super design of the Gemini, the foot support can be set into 4 different lengths: 25 – 28 –
31- 34 cm.
Adjust them as follows:
• Retract both blocking pins
• Adjust the undercarriage of the foot support into the desired
• Block the undercarriage again with the blocking pins
Adjusting the inclination of the foot support
The adjustment of the inclination of the foot support to a range of 60°, in combination with other
adjustments, will increase the possible positions of the Gemini.
Adjust them as follows:
• Turn both adjustment knobs from the regulator strips loose
• Adjust to optimal inclination for the foot support
• Lock again by tightening both adjustment knobs
Attention:
L Before use, make sure that the leg supports are securely locked in place.
L The position of the adjustment knobs has to be checked every time to prevent that they would be
in a position that would endanger the user.
L Never grasp the wheelchair by the leg supports when picking it up for transportation, but only by
solid frame parts.
L Never stand on top of the foot support as they are only meant to give support.
L We shall decline all liability for damage caused by improper use.
For a correct adjustment of the foot support, turn to your local dealer who will support you with
professional advise and technical support.
In case the disorder of your child makes the correct adjustment of the foot support difficult, turn to your
local dealer who will find a suitable and proper solution.
TYRES
The Gemini is by default equipped with inflated rear wheels (½ x 2 ¼), which are mounted, to the
undercarriage by use of axles with rapid-connections (B80) and with revolving inflated front wheels (8
x 1 ¾ (200x50)).
Removing the rear wheel
The fast and safe removal of the wheels is very convenient for transport in smaller cars.
By usage of the special axles B80, a fast removal is possible. Use your thumb to press the button on
the wheels to the inside. After that, the wheel can be removed.
For mounting the wheels again, the same procedure needs to be followed. Push the button on the
axle and slide in the wheel to lock it into position.
L A correct mounted wheels cannot be removed when the button of axle is clearly visible on the
outside.