Filter
Top Products
8
Assembly
Fit two elevator walls into the slots in an elevator fl oor.•
Hint: The elevator walls are designed to fit into the elevator floor one way. If they do not seem to
fit, turn them over and try again!
Push to • “snap” each in place.
Fit an elevator roof onto the elevator walls. Push near each of the four corners to • “snap”
in place.
Hint: The elevator roof is designed to fit onto the walls one way. If it does not seem to fit, turn it
around and try again!
Repeat this procedure to assemble the other elevator. •
Fit the center pegs on the elevator crane into the grooves in an elevator. Push to • “snap” the
elevator in place.
Hint: The elevator is designed to fit on the elevator crane one way. If it does not seem to fit, turn it
around and try again!
10
11
12
Elevator Walls
Elevator Floor
Elevator Roof
Pegs
Elevator