Filter
Top Products
T4963a-0921
9
• Fit the lock nut (rounded side up) on to the end of the
steering column.
• Tighten the lock nut firmly using the closed end of
the wrench.
End of Steering
Column
Lock Nut
Steering
Column
Cap
Wrench
Rounded Side Up
ASSEMBLY
3
Pull Up
• “Snap” the steering column cap over the steering
column and onto front wheel assembly.
4
• Turn the vehicle upright.
• Pull the handlebar up to be sure the steering column
is secure.
• If you can remove the steering column, you have not
assembled the steering column correctly. Please refer
back to Assembly steps 2-4.
• Plug the handlebar connector into the motor connector.
• Replace the seat (refer to step 6 on page 13).
Motor
Connector
Handlebar
Connector
SIDE VIEW
TOP VIEW
5
6