Filter
Top Products
7
7
• Fit a cap nut cover over each cap nut on the front end of the
frame. Push to “snap” in place.
Cap Nut Covers
• Turn the frame upside down on a flat surface.
• Fit an axle mount onto the pegs near the rear of the frame.
Hint: Each axle mount only fits on one side of the vehicle. If it does
not line up with the pegs on the frame, try fitting it to the other side.
• Insert three #8 x ¾” screws into the axle mount and tighten.
• Repeat this procedure to assemble the other axle mount to the
rear of the frame.
Axle Mount
BOTTOM VIEW
• Slide a rear bushing, long end first, onto the rear axle.
• Next, slide a wheel, smooth side first, onto the rear axle.
• Then, slide a hubcap, post side first, onto the rear axle.
Rear Bushing
Wheel
Hubcap
7 8
Rear Bu
11
Assembly
Assembly
• Fit a cap nut onto the end of the rear axle.
• Tap the cap nut with a hammer. Gently pull the wheel to make
sure the cap nut is securely attached to the rear axle.
Hint: You may need the help of another adult to hold the rear axle
in place while you tap the cap nut.
12
Cap
Nut