5
1
2
3
Fit the upper and lower walls together, as shown.•
Insert four screws into the holes in the wall assembly and tighten.•
Place the bases on a flat surface, as shown.•
Fit the wall assembly into each base and push to • “snap” in place.
Hint: The wall is designed to fit the bases one way. If it does not
seem to fit, turn or switch one or both bases around and try again!
Walls
Bases
4 Screws
Assembly
4
Locate the ramp labeled with a • 2.
Fit the ends of the ramp into the slots in the wall, as shown.•
Hint: The tab at the top of the ramp has a blue dot on it. Match
this dot to the slot with the blue dot.
Blue Dots
Top View
Top View
Ramp
Labeled 2