Filter
Top Products
R1502a-0920
3
• Slide a
7
/16" washer onto the rear axle.
• Slide a hubcap, indented side down, onto the rear axle.
• Slide a wheel onto the rear axle. Make sure the ribs on the
wheel face up.
• Slide a rear wheel driver, ring side down, onto the rear axle.
Fit the grooves on the rear wheel driver onto the ribs on the wheel.
• Slide another
7
/16" washer onto the rear axle.
• Position the vehicle upright. Face the back end of the vehicle.
• Slide the rear axle assembly into the hole in the opposite side
of the motor assembly. Make sure the rear wheel driver on the
rear axle assembly fits onto the pins in the motor assembly.
Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.
WARNING
9
ASSEMBLY
2
R1502a-0920
Hubcap
Rear Axle Assembly
Rear Axle
Motor Assembly Pins
Motor Assembly
• Remove the protective caps from each end of the rear axle and
throw them away.
• Fit a
3
/8" -16 lock nut onto one end of the rear axle.
Hand tighten the lock nut to hold it in place.
1
Rear Axle
Lock Nut
Rib
Wheel
Rear Wheel Driver
7
/16" Washer
7
/16" Washer