Filter
Top Products
R1502a-0920
• Remove the protective caps from each front axle and throw
them away.
• Slide a
7
/16" washer onto one of the front axles.
• Slide a round bushing, ring end first, onto the front axle.
• Slide a wheel (ribbed side first) onto the front axle.
• Slide a hubcap (indented side out) onto the front axle.
• Slide a
7
/16" washer onto the front axle.
• Fit a
3
/8" -16 lock nut on the end of the front axle and tighten
with the assembly wrench.
• Repeat this procedure to assemble the remaining
7
/16" washers,
round bushing, wheel, hubcap and
3
/8" -16 lock nut to the other
front axle.
• Fit a hub cap cover onto each front wheel and push to
"snap" in place.
• Slide a
7
/16" washer onto the rear axle.
• Slide the rear wheel driver onto the rear axle. Make sure the
rear wheel driver fits onto the pins in the motor assembly.
• Slide a wheel onto the rear axle. Make sure the ribs on the
wheel fit into the grooves on the rear wheel driver.
• Slide a hubcap, indented side out, onto the rear axle.
• Slide a
7
/16" washer onto the rear axle.
•
Fit a
3
/16" -16 lock nut on the end of the rear axle and hand tighten.
• Completely tighten the lock nuts on both sides of the rear
wheel assembly with the assembly wrenches.
Hint: An extra wrench has been provided to hold the lock nut
on one side of the rear axle while tightening the lock nut on
the other side.
•
Fit a hub cap cover onto each rear wheel and push to "snap" in place.
4
5
6
10
ASSEMBLY
7
8
R1502a-0920
Rear Wheel
Driver
Motor Assembly
Ring End
Hub Cap Cover
Hub Cap
Cover
Assembly
Wrench
Rear Wheel
Assembly
Wrench
7
/16" Washer
Hubcap
Rear Axle
7
/16"
Washer
Lock Nut
Wheel
Round
Bushing
7
/16"
Washer
Hubcap
Front Axle
7
/16"
Washer
Lock Nut