Filter
Top Products
CAUTION - ELECTRIC TOY
Not recommended for children under 3 years of age. As with
all electric products, precautions should be observed during
handling and use to prevent electric shock.
IMPORTANT SAFETY INSTRUCTIONS
-
SAVE THESE INSTRUCTIONS.
CONSUMER INFORMATION
• Please read this booklet before fi rst-time use. Keep these instructions for future reference,
as they contain important information.
• Adult assembly is required.
• Requires one 9.6V NiMH rechargeable battery pack (included) and three “AA” (LR6)
alkaline batteries (not included) for operation.
• Tool required for battery installation: Phillips screwdriver (not included).
• Before fi rst-time use, charge the 9.6V NiMH rechargeable battery pack for 4 hours.
Charge the 9.6V NiMH rechargeable battery only with the supplied charger. Do not use
any other charger.
• The charger is not a toy. Do not use extension cords with the charger.
• Adults Note: Adult supervision is required while charging the 9.6V NiMH battery. Regularly
examine the charger for damage to the cord, plug, housing or other parts that may result in
the risk of fi re, electric shock or injury. In the event of any damage, do not use the charger
until the damage has been properly repaired.
• Even with proper care, the rechargeable battery will not last forever. The life of the
rechargeable battery depends on how well you follow these instructions and the total
number of hours it is used. If you should need to replace the rechargeable battery,
contact Fisher-Price
®
.
• Do not disassemble the sealed 9.6V NiMH rechargeable battery pack.
• Do not recharge a battery pack that shows leakage or corrosion.
• Charger specifi cations: Input 120 VAC, 60 Hz, 0.3 A; Output 11.2 VDC, 360 mA, 4 VA.
• This product is intended for indoor use only.
• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not use
bleach. Do not use harsh or abrasive cleaners. Do not immerse.
• This product has no consumer serviceable parts. Do not take this toy apart.
DANGER
To prevent electric shock, do not immerse in
water; wipe clean with a damp cloth.
To reduce the risk of fire or electric shock,
carefully follow these instructions.
ASSEMBLY
• Match the shape on each leg to the shape on the dinosaur body .
• Fit the pegs on each leg into the sockets on the dinosaur body. Push each leg to “click” into
place. Make sure you hear a “click”.
IMPORTANT! For proper function, make sure all three pegs on each front leg are snapped into
the sockets on the dinosaur body.
BATTERY CHARGING AND INSTALLATION
• Plug the 9.6V NiMH battery connector into the charger connector.
• Plug the charger into a standard wall outlet. The charger L.E.D. turns red.
Notes: If power fl ow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
Use the charger only in a wall outlet. Do not plug the charger into a ceiling outlet. To connect to
a supply that is not in the United States, use an adapter (not included and sold separately) with
the proper confi guration for the power outlet.
• Charge the battery for four hours. When charging is complete, the charger L.E.D. turns green.
• Disconnect the charger connector from the battery connector. Unplug the charger from the
wall outlet.
Charger Connector
9.6V NiMH
Battery Connector
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
Remote Control
• Locate the battery compartment door on the bottom of the remote.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.
1.5V x 3
"AA" (LR6)
• Fit the tail onto the back of the dinosaur. Push the tail to “click” into place. Make sure you
hear a “click”.
Dinosaur
• Locate the battery compartment on the bottom of the dinosaur.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Plug the 9.6V NiMH battery connector into the dinosaur connector.
• Fit the connectors into the back slot in the battery compartment and then place the 9.6V
NiMH battery pack on top.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.