Filter
Top Products
6
Assembly
• Turn the frame upright.
• Insert the fork post up through the hole in the neck of the
frame. Make sure the fork is positioned so that the fork
covers face the rear wheels.
• Place the handlebar over the fork post and push it down
onto the frame. Make sure the handlebar is positioned so
that the screw hole faces the rear wheels and aligns with
the screw hole in the fork post.
Hint: You may need to rotate the handlebar to align
the holes.
• Insert the #8 x 3" screw through the hole in the handlebar
and into the fork post. Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
Handlebar
Frame Neck
Fork Post
Fork Cover
Rear of Trike
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #8 x
3
/
4
" screws through the fork cover and into
the fork arm. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to attach the other fork cover to the
other fork arm.
Fork Arms
Pedal Axle
Groove
Fork Cover
• Position the seat upside down.
• Fit the small pegs on the seat retainer into the holes in
the seat.
• Insert and “snap” the cap into the hole in the frame.
Cap
Seat Retainer
Seat
Peg
Holes
8
9
10
11