Filter
Top Products
6
Assembly
• Position a frame so that the
decorated side is outward.
• Insert the back frame legs into the back base.
• Fit a screw retainer over a hole in the back base, as shown.
• Insert a #10 x 2,2 cm black screw through the screw
retainer and back base. Tighten the screw.
• Repeat this procedure to fasten the other frame back leg to
the other side of the back base.
Hint: The #10 x 2,2 cm black screws may have been
assembled to the screw retainers.
Frame Decorated Side
Frame Back Legs
Back Base
Screw Retainers
8
• While pressing the levers on the seat height adjusters,
lift them to position 4 on the frame front legs, as shown.
Seat Height Adjusters
Position 4
Press Lever
9
• Fit the seat assembly between the two frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position
(position 4).
• You may need to push the frames apart slightly to fit the
seat bottom tubes into the seat height adjuster sockets.
Seat Assembly
Sockets
Seat Bottom Tubes
4
10