Filter
Top Products
4
Assembly
1
• Place the seat bottom face down on a flat surface.
• At an angle, fit the footrest to the seat bottom, as shown.
Seat Bottom
Footrest
• Slide a seat bottom tube through each set of plastic rings
on the seat bottom.
2
Plastic Rings
Seat Bottom Tubes
Plastic Rings
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or
sharp edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and instructions if
needed. Never substitute parts.
• Align the holes in the plastic rings and the seat bottom tubes.
• Insert a #8 x 1,9 cm screw through each plastic ring and into
the seat bottom tubes, as shown. Tighten the screws. This may
require extra force.
• Push the seat bottom tubes back and forth to be sure they
are secured to the seat bottom. If the seat bottom tubes
move, you have probably not fastened them properly. Remove
the screws and check to be sure the screw holes in the
seat bottom tubes and seat bottom plastic rings are aligned.
Replace and tighten the screws.
3