Filter
Top Products
5
Square Openings
5
Seat Back Tube
• Position the seat back tube so that the square openings
are upright.
• Fit the seat back tube onto the ends of the base wire.
• Push the seat back tube to be sure it is completely on the
base wires.
Assembly
• Insert a #8 x 1,9 cm (
3
/
4
") screw into the inside hole of each
handle and tighten.
• Pull up on the seat back tube to be sure it is secured to the
left and right base wires.
6
Bottom Pocket
• Fit the handles through the side openings in the pad.
Handles
• Fit the pad seat back pocket over the seat back tube.
• Pull and fit the pad seat bottom pocket around the soothing
unit and footrest.
Seat Back Pocket
8
7