Filter
Top Products
4
• Place the base tube on a flat surface.
• Position the left and right base wires as shown.
• Fit the left base wire and right base wire into the base tube.
1
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or
sharp edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and instructions if needed.
Never substitute parts.
Right Base Wire
Base Tube
Left Base Wire
Assembly
• Position the feet so the holes are toward you and the
non-skid surface is down.
• Fit the feet on the base tube, as shown.
Feet Holes
2
• Insert an M5 x 20 mm screw through each foot and tighten.
3
• Position the footrest so that the soothing unit is upright.
• Fit the footrest onto the ends of the base wires.
Base Wires
4
Footrest