Filter
Top Products
Assembly
Flex Base Wires Inward
• While flexing the base wires toward each other, hook the
footrest onto the ends of the base wires.
• Push the footrest down completely to the tabs on the base
wires.
4
3
• Insert an M5 x 20 mm screw through each foot and tighten.
Tabs
• Position the seat back
tube above the base
assembly.
• Fit the seat back tube
completely onto the
base wires.
• Fit a retainer (rounded
side inward) to one
end of the seat back tube.
• Insert a #8 x 1,9 cm screw through the outside hole in
the seat back tube and into the retainer.
• While holding the retainer in place, tighten the screw.
• Repeat this procedure to secure the other side of the
seat back tube to the base assembly using the remaining
retainer and #8 x 1,9 cm screw.
• Pull up on the seat back tube to be sure it is secure. If you
can remove either end of the seat back tube, you have not
assembled it correctly. Remove the screws and retainers.
Re-read and repeat Assembly step 5.
Base Wire
Base Wire
Seat Back Tube
Retainers
5
Pull Up
5