Filter
Top Products
6
7
Assembly
• Pull the frame leg out on each frame to open. Make sure it "clicks"
into place.
• Position a frame so that the decorated side is outward.
• Fit the end of the back base into the back leg of a frame.
• Fit a screw retainer over the hole in the back leg, as shown.
• Insert a #10 x 2,2 cm black screw through the screw retainer and
back leg. Tighten the screw.
• Repeat this procedure to fasten the other frame back leg to the
other side of the back base.
Hint: The #10 x 2,2 cm black screws may have been assembled to
the screw retainers.
Frame Decorated Side
Frame Back Legs
Back
Base
Screw Retainers
Frame Leg
8
• While pressing the levers on the seat height adjusters, lift them to
position 4 on the frame front legs, as shown.
Seat Height Adjusters
Position 4
Press Lever
4
9
• Fit the seat assembly between the frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position
(position 4).
• You may need to push the frames apart slightly to fit the seat
bottom tubes into the seat height adjuster sockets.
Seat Assembly
Seat Bottom
Tubes
Sockets
Sockets