Filter
Top Products
4
1
• Place the seat bottom face down on a flat surface.
• At an angle, fit the footrest on the seat bottom, as shown.
Assembly
Seat Bottom
Footrest
• Slide a seat bottom tube through each set of plastic rings on the
seat bottom.
2
Plastic Rings
Seat Bottom Tubes
Plastic Rings
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel for
replacement parts and instructions if needed. Never substitute parts.
• Align the holes in the plastic rings and the seat bottom tubes.
• Insert a #8 x 1,9 cm screw through each plastic ring and into the
seat bottom tubes, as shown. Tighten the screws. This may require
extra force.
• Push the seat bottom tubes back and forth to be sure they are
secured to the seat bottom. If the seat bottom tubes move, you have
probably not fastened them properly. Remove the screws and check
to be sure the screw holes in the seat bottom tubes and seat bottom
plastic rings are aligned. Replace and tighten the screws.
3