Filter
Top Products
7
Kickstand
• Rotate the kickstand out.
• Push down on the seat bottom to be sure the kickstand is in position.
2
Restraint Belt Restraint Belt
Restraint Pad
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the restraint belts to each side of the restraint pad.
Make sure you hear a “click” on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
3
Setup and Use
Restraint System
4
• Tighten each waist belt so that the restraint system is snug
against your child. Please refer to the next section for instructions
to tighten the waist belts.
Anchored End Anchored End
Free End
Free End
TIGHTEN
LOOSEN
To tighten the belts:
• Feed the anchored end of the restraint belt up through the buckle
to form a loop . Pull the free end of the restraint belt .
To loosen the belts:
• Feed the free end of the restraint belt up through the buckle to form
a loop . Enlarge the loop by pulling on the end of the loop toward
the buckle. Pull the anchored end of the restraint belt to shorten the
free end of the restraint belt .
5
Plug
Toy Bar
• Fit the plugs on each end of the toy bar into the sockets in each
side rail.
• Attach the toy straps to the toy bar straps, or attach the toy straps
to any of the straps on the pad.
• Make sure your child is properly secured in the seat.
• Slide the power switch to the
on position for calming vibrations.
Slide the power switch to the off position to turn vibrations off.
Plug
Power Switch
6