Filter
Top Products
6
6
6
Assembly
8
• Identify the back and front base. The front base has tapered leg
tubes. You will use the back base for the next assembly step.
Tapered Leg Tube
Back Base
Front Base
9
Screw Retainer - 2
#10 x 2.2 cm Black Screw - 2
• Position a frame so that the decorated side is outward.
• Insert the back leg of a frame into the back base.
• Fit a screw retainer over the hole in the back base, as shown.
• Insert a #10 x 2.2 cm black screw through the screw retainer
and back base. Insert the back leg of a frame into the back
base. Tighten the screw.
• Repeat this procedure to attach the other frame back leg
to the other side of the back base.
Hint: The #10 x 2.2 cm black screws may have been assembled to the
screw retainers.
Frame Back Legs
Frame Decorated Side
Back Base Hole
Screw Retainers
Back Base Hole
10
• While pressing the levers on the seat height adjusters, lift them
to position 4 on the frame front legs, as shown.
Seat Height Adjusters
Position 4
Press Lever
11
• Fit the seat assembly between the two frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position (position 4).
• You may need to push the frames apart slightly to fit the seat bottom
tubes into the seat height adjuster sockets.
Seat Bottom Tubes
Sockets
Seat Assembly