Filter
Top Products
4
1
• Place the frame upside down on a flat surface. Make sure the steering
linkage assembly is fitted to the front end of the frame.
• Remove the tape holding the front axles to the frame. Rotate the front
axles out.
2
• Push the front axles down into the groove in each end of the
steering linkage.
3
• Fit the peg on the footrest into the hole inside the frame.
• Insert the
1
/
4
" x 1
1
/
4
" screw into the footrest and tighten.
PUSH
Assembly
Steering Linkage
Assembly
Frame
Front Axles
Groove
Groove
PUSH
Footrest Peg
4
• While holding the steering linkage assembly in place, carefully turn
the frame upright.
• Fit a .354" cap nut onto the upright end of a front axle.
• While holding the front axle in place, tap the cap nut with a hammer
to secure it to the front axle. Pull up on the cap nut to be sure it
is secure.
Hint: You may need the help of another adult to hold the front axle
in place while you tap the cap nut with a hammer.
• Repeat this procedure to assemble another cap nut to the other
front axle.
.354"
Cap Nuts
Front Axles
.354"
Bottom View
Front Side View