Filter
Top Products
•Place the seat bottom face down on a flat surface.
•At an angle, fit the footrest on the seat bottom, as shown.
Seat Bottom
Footrest
IMPORTANT! Before assembly, inspect this product for
damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing, damaged
or broken. Contact Mattel for replacement parts and
instructions if needed. Never substitute parts.
Assembly
•Slide a seat bottom tube through each set of plastic rings
on the seat bottom.
•Align the holes in the plastic
rings and the seat bottom tubes.
• Insert a #8 x 1.9 cm (
3
/4") screw
into each plastic ring and tighten.
•Push the seat bottom tubes back and forth to be sure they
are secured to the seat bottom. If the seat bottom tubes
move, you have probably not fastened them properly.
Remove the screws and check to be sure the screw holes in
the seat bottom tubes and seat bottom plastic rings are
aligned. Replace and tighten the screws.
• Insert two #10 x 2.2 cm (
7
/8")
black screws through the foot-
rest and into the seat bottom.
•Tighten the screws.
Footrest
Insert Screws
Here
4
Plastic
Rings
Plastic
Rings
Seat Bottom Tubes
Plastic
Rings
Plastic
Rings
Seat
Bottom
Tubes
1
2
4
3
#8 x 1.9 cm (
3
/
4") Screw- 4
SHOWN ACTUAL SIZE
#10 x 2.2 cm (
7
/
8")
Black Screw - 2
SHOWN ACTUAL SIZE