Filter
Top Products
Assembly
8
•Position the seat back tube so that it bends backward.
•Fit the seat back tube completely onto the base wires. Make sure the hole
in each end of the seat back tube aligns with the hole in each base wire.
•Fit a retainer (rounded side inward) to one end of the seat back tube.
• Insert a screw through the outside hole in the seat back tube and into
the retainer.
•While holding the retainer in place,tighten the screw with a Phillips screw-
driver. Do not over-tighten.
•Repeat this procedure to secure the other side of the seat back tube to the
base assembly using the remaining retainer and screw.
3
Base
Wire
Base
Wire
Seat Back
Tube Bends
Backward
Retainers