Filter
Top Products
Stage 2 - Sit & Play
4
4
• Rotate the hangers up and “snap” them into place.
• Attach the toys to the hangers and tabs as shown.
• While pressing the star buttons on a support, fit the
end of the support into the large slot in one of the
legs, as shown. The support should “snap” in place.
• Repeat this procedure to attach the other support to
the remaining leg.
2
2
1
1
•Position the keyboard so it faces up.
• Fit a leg assembly to the side of the keyboard, as shown.
•Turn the knob clockwise to secure the leg assembly to
the keyboard. Make sure the knob is fully tightened.
• Repeat this procedure to attach the other leg assembly
to the keyboard.
3
3
Star Button
Large Slot
Support
Leg Assembly
Tab
Hanger
• Slide the mode switch to . When baby presses a key, part
of a song plays with twinkling lights. With each press of a
key, the song continues building, a little at a time.
• Slide the mode switch to .When baby presses a key,
musical scales or chords play as twinkling lights
follow along.
• Locate the volume switch on the bottom of the keyboard.
Adjust volume to high
;
or low , for your child’s comfort.
Stage Switch
• Slide the stage switch to for use with babies
sitting up.
Hint: If your child is not actively playing with this toy, it
turns off automatically (sleep mode).
• Be sure to slide the stage switch to the off position
when not in use.
Leg Assembly
Knob
Mode Switch
Volume Switch
5
Leg
To change from Stage 1 to Stage 2
•Turn the threaded knobs counter-clockwise and
detach the leg assemblies from the keyboard.
• Press the star buttons and remove the two
supports from the legs. Now proceed to step 2.
If you have not used this toy before and are
assembling it for first time use in Stage 2, start
with Step 2.