Filter
Top Products
Assembly
6
Hubs
Seat Frame Tubes
Plastic
Housing
Press Buttons
8
• Insert a screw into each hub
and each seat frame tube.
•Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Seat Frame Tubes
Hubs
Insert Screws
9
#8 x 1
1
/
4
" Screw – 2
Shown Actual Size
•Decide which side of the reversible pad you will use. One
side of the pad has a soft, cotton material with ruffle (for
swing use); the other side is a wipeable vinyl material (for
high chair use).
•Fit the pocket on the back of the reversible pad onto the
seat back.
• Insert the crotch restraint through the large rectangular
opening in the pad.
10
Crotch
Restraint
Pad
•Position the frame assembly so that the curved, front base
is towards you.
•Fit the seat frame tubes into the hubs on the frame
assembly.
•Press the upper buttons on the seat frame tubes and insert
them into the hubs on the frame assembly until they “snap”
into place. Make sure you hear a “snap”on both sides.
•Fit the waist restraints through the smaller slots in the
reversible pad.
•Fasten the fasteners on the sides of the reversible pad to
the back of the seat.
•Fit the bottom edge of the reversible pad around the bot-
tom edge of the seat.
Assembly is now complete.
IMPORTANT! Before first-time use, please read and under-
stand how to install batteries, setup, use, store and care
for Swing ‘n Meals™.
11
Waist Restraints
Fastener Fastener
79739b-0920.qrk 10/25/01 11:11 PM Page 6