Filter
Top Products
Fisher-Price
®
• Fit the metal frame curved ends into the grooves in the
footboard.
F
is
h
e
r
-P
ric
e
®
• Insert four barrel nuts into the metal frame curved ends.
• Insert four screws into the outside of the footboard and
hand tighten the hardware.
• While holding a barrel nut in place with a Phillips screw-
driver, tighten the screw with the other Phillips screw-
driver. Do not over-tighten. Repeat this procedure to tighten
the other screws.
Toddler bed assembly is now complete.
Footboard
Metal Frame Curved End
Groove
Footboard
Toddler Bed Assembly
• Push down on the metal frame to completely insert it into
the grooves in the left and right side panels.
12
• Insert two barrel nuts into the metal frame located on the
inside of the left side panel, as shown.
• Insert two screws into the outside of the left side panel and
hand tighten the hardware.
• While holding a barrel nut in place with a Phillips screwdriv-
er, tighten the screw with the other Phillips screw-
driver. Do not over-tighten. Repeat this procedure to tighten
the other screw.
• Repeat this step to secure the right side panel to the
metal frame.
• Turn the assembly right side up.
13
14
15
Metal Frame
Left Side Panel
36
Screws
Barrel Nuts
Screws