Filter
Top Products
16
To remove the pad:
• Remove the toy bar.
• Lift the footrest wire and remove the pad lower pocket.
• Fit the restraint straps back through the slots in the pad.
• Slide the pad upper pocket off of the seat back wire.
To re-assemble the pad:
• Refer to Assembly steps 5 and 6.
The pad is machine washable. Wash the pad separately
in cold water on the gentle cycle.
Do not use bleach. Tumble dry separately on low heat
and remove promptly. The frame, toy bar,
mirror, paddles, butterfly and flowers may be wiped clean
using a mild cleaning solution and a damp cloth.
Do not immerse the soothing unit or toy bar.
CARE
FCC Note (United States Only)
15
SET-UP & USE
5
Soothing Vibrations
• Make sure your child is properly secured in the seat.
• Slide the ON/OFF switch on the soothing unit to the “ON” position.
The seat will vibrate.
• Slide the ON/OFF switch on the soothing unit to the “OFF” position.
The seat will not vibrate.
IMPORTANT! If vibrations from the soothing unit become faint, or if there
are no vibrations, remove the battery from the soothing unit and dispose of it
properly. Replace the battery with a new, size “D” (LR20) alkaline battery.
Sounds and Lights
Long-Play Mode
• Slide the switch to for long-play mode. Baby delights to five minutes
of music and light patterns when the mirror is batted.
Short-Play Mode
• Slide the switch to for short-play mode. Baby enjoys one song and a
light pattern when the mirror is batted.
Off
• Slide the switch to to turn off sound and lights.
4
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©1999 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in China 79008pr-0920
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Switch
Switch