Filter
Top Products
5
Assembly
• Fit the counter top onto the main assembly.
•Insert 10 screws through the main assembly and into
the counter top. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
•Position the refrigerator door with the handles
facing you.
• At an angle, fit the refrigerator door lower peg into the
lower hole in the hinge on the side panel.
• Then, "snap" the refrigerator door upper peg into the
upper hole in the hinge.
• Place the base on a flat surface with the open side
facing up.
• Set the main assembly onto the base. Fit the tabs
on the bottom of the main assembly into the slots
in the base.
• Press down on the main assembly to "snap" it into
the base.
9
11
Tab
Slot
•Position the counter top over the main assembly so
that the stove top is over the oven door.
• Plug the remaining small connector from the main
assembly into the connector from the counter top
as shown.
10
Stove Top
Counter Top
Oven Door
8
Base
Hinge
Connector from
Counter Top
Small Front
Panel Connector