Filter
Top Products
Assembly
T
M
• Insert a #8 x 1" screw into each of the two inner screw
holes in the top of the front bumper.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Insert a #8 x 1" screw into each of the two outer screw
holes in the top of the rear bumper.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Inner
Holes
Front Bumper
Rear Bumper
Outer
Holes
12
Right
Taillight
Lens
Left
Taillight
Lens
Left Right
Slots
Tab
13
• Using safety scissors, remove the taillight lenses from
the plastic connector. Dispose of the plastic connector.
• Face the rear of the vehicle.
• Insert the tabs on the back of the right and left taillight
lenses into the taillight slots in the vehicle body.
Please Note: The left and right taillight lenses are NOT
interchangeable.
• Press firmly to snap the tabs into the slots.
14
Pegs
Tailgate
Tailgate
Openings
Flat Side
• Position the tailgate with the flat side facing up.
• Fit the peg on one side of the tailgate into the tailgate
opening in the rear of the vehicle body.
• Slide the peg on the other side of the tailgate into the
tailgate opening in the other side of the vehicle body.
• Lift the tailgate and press firmly to snap it closed.
12