Filter
Top Products
Battery Installation
Important Note: Use only Power Wheels
®
Type H batter-
ies with Power Wheels
®
30 amp fuses installed. Use of any
other batteries or fuses will damage your vehicle. Make
sure that you charge the batteries for at least 18 hours
using the enclosed Power Wheels
®
12 volt charger before
operating your vehicle for the first time. Charge
the batteries for at least 14 hours after each use of the
vehicle. Never charge the batteries longer than 30 hours.
Failure to follow these instructions may damage your
batteries and will void your warranty.
It is easier to install the batteries before assembling the
hood to your vehicle. If you have already assembled the
hood to your vehicle, you may want to remove it to install
the batteries.
2
1
H
• Re-assemble the hood to the vehicle if you have removed
it to install your batteries.
• Lower the hood.
• Face the front of the vehicle.
• Using a slotted screwdriver, rotate the lock-fasteners in
the hood so that they are horizontal ( ).
• Press down on the hood so that the lock fastener tabs on
the underside of the hood fit into the lock fastener slots
under the hood in the battery compartment.
• Rotate the lock fasteners clockwise 90˚ (
1
/
4
turn) using a
slotted screwdriver to lock the hood and prevent children
from accessing the batteries ( ).
• Lift up on the hood to make sure it is securely fastened.
• Position the battery retainer over the batteries with the
ends of the battery retainer aligned with the screw holes
in the battery compartment.
• Insert two #8 x 1" screws through the battery retainer
and into the battery compartment.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Place the connectors toward the rear of the battery
compartment, on top of the battery, as shown.
• The battery compartment is located under the hood of
your vehicle.
• Place both batteries upright in the battery compartment.
Make sure the bottoms of the batteries are flat on the
bottom of the battery compartment and that the battery
connectors extend toward the rear of the vehicle.
• Make sure a Power Wheels
®
30 amp fuse in good
condition is installed in each of the batteries and that
the battery connectors are snapped together.
Power Wheels
®
30 Amp Fuses
Batteries
Battery
Connectors
Batteries
Battery Connectors
Motor Harness
Connector
• Squeeze the tabs on each side of the motor harness
connector.
• Plug the battery connector into the motor harness
connector.
Battery
Retainer
Lock
Fasteners
Lock
Fasteners
Hood
Top View
Please Note: If the battery connector will not plug into
the motor harness connector, turn it over and try again!
Do not force the battery connector into the motor harness
connector.
15
3
4