Filter
Top Products
4
Assembly
• Fit the tabs on the bottom of the
windshield into the slots on the bumper.
• Push down on the windshield to "snap"
it into place.
• Push the tabs on the kickplate into the
slots on the windshield and "snap" the
two together.
• Position the kickplate so that the deco-
rated side faces you.
• Fit one of the pegs on the bottom of the
kickplate into one of the holes near the
base of the bumper.
• Bend the kickplate slightly to fit the
other peg into the corresponding hole
on the other end of the bumper.
Bumper
Kickplate
Windshield
1
1
2
2
3
3
Peg
Hole
Arm
Base
• Fit an arm to the hub on a base
as shown.
• Insert the #8 x 1
3
/
8
" washer head screw
through the hole in the arm and into the
base.Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure to attach the
other arm and base.
4
4
#8 x 1
3
/
8
" Washer Head Screw
Shown Actual Size
Hub
• Insert the ends of each base into the
square slots in the bumper assembly
as shown.
5
5
Base Ends
Bumper
Assembly