Filter
Top Products
4
• Position track 2 with the grooved side up. Fit track 2 onto the
center tube.
• Rotate track 2 counter-clockwise until it meets track 1. Insert
and “snap” the tab on the end of track 2 into the slot in
track 1. Be sure the peg on the end of track 2 fits into the
hole in track 1.
• Repeat this process to assemble track 3 to track 2.
Hint: When the tracks are properly fitted on the center tube, a tab on
the center tube should be visible above each track.
9
Track 2
Track 1
Center Tube
•Align the smallest tab on the center tube with the smallest
slot in the base. Push down on the track support to “snap”
the center tube into place.
Base
• Locate track 1. Position track 1 with the grooved side up.
•Fit track 1 onto the center tube. Rotate it counter-clockwise
until it reaches the base.
• Insert and “snap” the tab on the end of track 1 into the slot
in the base.
8
Center Tube
Track 1
Tab
7
Base Slot
Tab
Peg
Hole
Center Tube
Small Tab
Base Small Slot
PUSH
PUSH
• Insert a #6 x
3
/
8
" screw through the hole in track 3 and into
the tube. Tighten the screw with a Phillips screwdriver.
Do not over-tighten
10
Track 3
Center Tube
#6 x
3
/
8
" - Screw
Shown Actual Size