Filter
Top Products
• Insert a lock washer into the pedal slot. Make sure the
raised tabs on the lock washer are facing the closed, or
outside end of the pedal.
• Repeat this procedure to fit the other lock washer into the
other pedal.
Outside End of Pedal
Pedal Slot
Raised Tabs
• Snap a rear wheel cover into the recessed area in each
rear wheel.
• Fit the slots in the pedal hubs onto the metal tabs on the
front axle.
• Snap the pedal hubs together securely.
• Slide the front wheel cover onto one end of the front axle so
that the pedal hub fits into the square recessed area inside
the front wheel cover.
• Insert the front axle assembly into the front wheel. Make
sure the two posts on the front wheel cover fit into the
corners of the square opening in the front wheel.
• Slide the other front wheel cover onto the front axle
assembly. Align the posts on the front wheel cover with the
holes in the front axle assembly.
• Insert two 1
1
/4
"
screws into each front wheel cover. Tighten
the screws with a Phillips screwdriver. Do not over-tighten.
Metal Tab
4
Assembly
Rear Wheel Cover
Front Axle
Pedal Hubs
Post
Front Axle
Front Wheel Cover
Front Axle
Assembly
Front
Wheel
Post
Front Wheel Cover
Lock Washer
Pedal Hub
Front Wheel
Cover