Filter
Top Products
• Place the play quilt print side up on a flat surface.
• Attach the activity toys to the straps on the sides of the
play quilt and place the toys on top of the quilt.
• Locate the fastener strap at one end of the play quilt. Place
the supports and tubes at the opposite end of the play quilt
and roll the play quilt from end to end.
• Fit the fastener strap through the loop on the outside of the
play quilt and fasten to close.
Fastener Strap
Fastener Straps
Tube
Support
Slots
Plastic Tab
Sleeve
Plastic Tab
Fastener
Straps
Assembling the Barn Battery Replacement
Battery Tips
Carry-Along
Activity
Toys
Battery Compartment
Battery Compartment Door
Activity Toys
Activity Toy Straps
• Slide the tubes through the sleeves in each side of the
play quilt.
• Position the supports so that the sides with the slots
face inward.
• Fit the two small fastener straps on each end of the
tubes through the slots inside the circular openings in
the supports. Fasten the fastener straps together to
secure the tubes to the supports.
• Fit the plastic tabs at the corners of the play quilt into
the slots in the supports.
• Fasten the activity toys to the activity toy straps.
• Locate the battery compartment door on the back of the
chicken activity toy.
• Loosen the screw in the battery compartment door with a
Phillips screwdriver. (The screw will remain in the door.)
• Lift the battery compartment door to open.
• Remove the used batteries and dispose of them properly.
• Insert two new button-cell (LR44 or equivalent) alkaline
batteries in the battery compartment as shown. Make sure
the flat side of each battery (printed with the battery desig-
nation) faces up.
Helpful Hint: We recommend using alkaline batteries for
longer battery life.
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
• When lights or sounds from this toy become faint or stop
working, it’s time to replace the batteries!
2 x LR44 or Equivalent
Shown Actual Size
This product contains small parts.
Batteries must be replaced by an adult.
CAUTION
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the toy. Battery
leakage and corrosion can damage this toy. Dispose of
batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recom-
mended in the "Battery Replacement" instructions are to
be used.
3