Filter
Top Products
Battery Compartment Door
The receiver operates either with the AC adaptor
included with your Sound ’n Lights Monitor
or with a 9 volt alkaline battery.
• Locate the battery compartment door on the bottom of
the receiver.
• Push the finger tab on the battery compartment door to
open the battery compartment door.
• Snap the terminals of a fresh 9v alkaline battery into the
connectors.
• Close the battery compartment.
Please Note:
• Remove the battery during long periods of non-use.
Always remove an exhausted battery from the product.
Battery leakage and corrosion can damage the product.
• Never short circuit the battery terminals.
• A non-rechargable battery is not to be recharged.
• Only a battery of the same or equivalent type as
recommended in the “Battery Installation”instructions is
to be used.
IMPORTANT NOTE! To prevent entanglement, never
place the transmitter in a crib or playpen. Place the
transmitter, receiver and AC adaptor cord(s) out of
baby’s reach.
OFF
ON
P
O
W
E
R
C
H
A
N
N
E
L
A
B
F
is
h
e
r
-P
r
ic
e
®
Channel Switch
Antenna
AC Adaptor
On/Off Switch
Power
Indicator
• Place the transmitter in the same room with your child.
For best sound pick-up, point the microphone directly
toward the crib or play area.Make sure the antenna
points upward for best transmission.
• For best transmission, unwrap and fully extend the
AC adaptor cord. Insert the AC adaptor jack into the
transmitter socket.
• Insert the plug into a standard wall outlet.
• Set the transmitter channel switch to the same channel
as the receiver.
• Slide the on/off switch on the front of the transmitter to
the “ON” position.The power indicator will light.
Set-Up and Use
E
Plug
AC Adaptor Jack
9V
(LR6)
4
Battery Installation
D
• If a removeable rechargeable battery is used, it is only to
be charged under adult supervision.
• A rechargeable battery is to be removed from the
product before it is charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
Shown Actual Size
Transmitter
Socket
Finger
Tab