Filter
Top Products
4
Assembly
• Insert the back legs on the swing frame into the base tube.
• Insert two M5 x 27 mm screws into the back legs and tighten.
Screws
Screws
• Position the seat frame so that the tubes are upright, as shown.
Hint: Note the location of the socket inside each seat hub.
The ends of the frame arms will be inserted into these sockets.
• Fit the end of each frame arm into the socket in each seat hub.
Frame Arms
Seat Frame
3
4
• Insert a #6 x 2,5 cm screw through the outside of each seat
hub. Tighten the screws.
• Fit the pad pockets onto the seat frame, as shown. Open the seat.
• From behind the assembly, insert the waist belts through the
slots in the pad.
• Press to fasten the waist belt assembly to the pad.
Waist Belts
Slots
5
6